To create a template for Men’s Hair System, simply follow the below instructions
Simple hair piece Template Measurement
For more precise measurement for your hair system. You can create a template as described below and send to us.
What you need: To create a template for your male hair system, you will need some cling film, a permanent marker and some clear cello tape.
Step 1:Place the plastic wrap 16 inches x16 inches over the balding area over lapping the hair line and forehead about 3 inches. Tape the plastic wrap to the face and back of head to hold in place. Perimiter taping around the forehead just above the eyebrows and around the back of head and back to the eye brows is best.
Step 2:Across the head place strips of tape across the plastic wrap side by side over lapping the hair line and forehead by at least one inch. Make another layer in the opposite direction from forehead to back of head side by side over lapping at least one inch. See image below.
Step 3:Using a marker trace around the template the outline of the balding area and the forehead. Mark the direction you want the hair to lay. Show part if any or leave blank for free style. The forehead line should start three or four fingers above the eye brows in a curve shape.
Step 5: Place one more layer of tape across the template in the opposite direction. You should be able to see the marking through this layer of tape.
Step 6: Carefully remove the template from your head and use a scissor to cut the area around the perimeter marked with the marker . The template should look similar to the photo shown.
For a full wig template:The markings are the same. Use a larger piece of plastic wrap, say 18″x18″ and follow the instructions above. The template should look similar to the photo shown.